100mm ElectroGal U-bolt Clamp Kit
100mm ElectroGal U-bolt Clamp Kit
100mm ElectroGal U-bolt Clamp Kit with plates are used to clamp equipment onto boat trailer, 4WD's or trailers. A good variety of other size clamp kits are available below.
U-bolt kit includes
- 1 x ElectroGal U-bolt
- 2 x Galvanised Nylocks
- 2 x Galvanised Washers
- 1 x 8mm ElectroGal Shackle Plate
Available Lengths are
- 75mm
- 100mm
- 125mm
- 150mm
- 200mm
Used to clamp suspension brackets onto 100mm chassis rails on boat trailers. The break load limit of these u-bolts has been tested sheer at 17.5t.
Tip: Tightening with a rattle gun can cause uneven tension on the clamp. Rattle guns also melt the nylock causing it to be ineffective. Once a nylock nut has been used and removed from service, we recommend replacing this nut.
U-bolts are mild steel and require checking for tightness after the first 100 kilometres of travel. MIld steel stretches upon initial tightening so it is best to check.
- Inside measurement is 100mm
- Measure Inside of top to tip of thread to obtain the desired thread length
- 1/2" U bolts with a 50mm thread
Read why u-bolts could be the major cause of accidents
This article is the catastrophic result of the incorrect tightening of u-bolt on a truck chassis
Additional information
| Weight | 1 kg |
|---|---|
| Dimensions | 8 × 6 × 6 cm |
| Clamp Length | 75mm, 100mm, 125mm, 150mm, 200mm |
